- To fill static cracks of 3 to 8 mm width.
- To correct the undulation of ceilings and walls before painting
Property |
BESTBUILD Crackseal |
Appearance |
Free flowing powder |
Colour |
White |
Recommended For Crack Width Of |
3 to 8 mm |
Bulk Density |
1.10 gm/cc +/- 0.10 |
Setting Time |
3 hours |
All technical data stated in this website are based on laboratory tests. Actual measured data may vary due to circumstances beyond our control.
- 1. Clean the surface to remove all loose particles, dust, etc. The cracks to be filled should be chiselled to form a ‘V’ groove.
- 2. Add 2.5-3 parts of powder to 1 part of clean water and mix by hand or slow speed mixer (<300 rpm).
-
- 3. Moisten the surface and fill the mixed paste into the crack by hand, spatula or putty knife blade.
- 4. Fill additional material and press it with knife blade against the cracks so that air voids gets filled.
- 5. Repeat the procedure till the full length of crack is filled.
Mixing Ratio (by weight) |
1 (water) : 2.5-3 (powder) |
Pot Life |
Around 1 hour |
Painting |
After 24 hours |
- 1. BESTBUILD CRACKSEAL is for static joint only. It cannot be used for moving cracks.
- 2. For exterior use, BESTBUILD CRACKSEAL must be coated with exterior paint to prevent water penetration.
-